Setting Up and Using Your Computer 45
NOTE: Most commercial DVDs have copyright protection and cannot be copied
using Roxio Creator Plus.
1
Open Roxio Creator Plus.
2
Under the
Copy
tab, click
Disc Copy
.
3
To copy the CD or DVD:
•
If you have one CD/DVD drive
, ensure that the settings are correct, and
then click
Disc Copy
. The computer reads your source CD or DVD
and copies the data to a temporary folder on your computer hard drive.
When prompted, insert a blank CD or DVD into the drive and
click
OK
.
•
If you have two CD/DVD drives
, select the drive into which you have
inserted your source CD or DVD, and then click
Disc
Copy
. The
computer copies the data from the source CD or DVD to the blank
CD or DVD.
Once you have finished copying the source CD or DVD, the CD or DVD
that you have created automatically ejects.
How to Copy a Blu-ray Disc™ (BD) Media
For information on how to use the BD media, refer to the manual that
accompanies the product.
Using Blank CDs and DVDs
CD-RW drives can write to CD recording media only (including high-speed
CD-RW media) while DVD-writable drives can write to both CD and DVD
recording media.
Use blank CD-Rs to record music or permanently store data files. After the
maximum storage capacity of a CD-R is reached, you cannot write to that
CD-R again (see the Sonic documentation for more information). Use blank
CD-RWs if you plan to erase, rewrite, or update information on the CD later.
Blank DVD+/-Rs can be used to permanently store large amounts of data.
After you create a DVD+/-R disc, you may not be able to write to that disc
again if the disc is finalized or closed during the final stage of the disc creation
process. Use blank DVD+/-RWs if you plan to erase, rewrite, or update
information on the disc later.
book.book Page 45 Tuesday, November 27, 2007 10:29 AM
To Next Page
Loading...
