148 Removing and Installing Parts
Processor Airflow Shroud
CAUTION: Before you perform this procedure, follow the safety instructions
located in the Product Information Guide.
Removing the Processor Airflow Shroud Assembly
1
Follow the procedures in "Before You Begin" on page 99.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 101).
CAUTION: The processor heat sink can get very hot during normal operation. Be
sure that the heat sink has had sufficient time to cool before you touch it.
3
Disconnect the fan cable from the FAN_CPU connector on the system
board (see "System Board Components" on page 103).
1 processor airflow shroud 2 captive screws (2)
2
1
book.book Page 148 Tuesday, November 27, 2007 10:29 AM
To Next Page
Loading...
