112 Removing and Installing Parts
8
Place the card in the connector and press down firmly. Ensure that the card
is fully seated in the slot.
9
Before you close the card retention door, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
1 fully seated card 2 not fully seated card 3 bracket within slot
4 bracket caught
outside of slot
5 alignment bar 6 alignment guide
1
2
3
4
6
5
book.book Page 112 Tuesday, November 27, 2007 10:29 AM
To Next Page
Loading...
