Removing and Installing Parts 131
5
If your replacement hard drive does not have the hard-drive bracket
attached, remove the bracket from the old hard drive by unsnapping it
from the drive.
6
Snap the hard-drive bracket bracket onto the replacement hard drive.
7
Install the hard drive into the computer by sliding the drive into place
until it clicks into place.
8
Connect the power and hard drive cables to the hard drive.
1 hard drive 2 hard-drive bracket
1 power cable 2 hard drive cable
1
2
2
1
book.book Page 131 Tuesday, November 27, 2007 10:29 AM
To Next Page
Loading...
