Hard Drive 15
Replacing the Hard Drive
1
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use
excessive force, you may damage the connector.
2
Replace the two screws on either side of the hard drive to connect it to the
bezel.
3
Slide the hard drive into the bay.
4
Replace and tighten the four screws on the hard drive cover.
5
Install the operating system for your computer, as needed (see "Restoring
Your Operating System" in your computer
Owner’s Manual
).
6
Install the drivers and utilities for your computer, as needed (see
"Reinstalling Drivers and Utilities" in your computer
Owner’s Manual
).
1 hard drive bezel 2 screw (2)
To Next Page
Loading...
