52 Battery Latch Assembly
8
Remove the spring from the hook on the computer base by lifting it up
and away with a screwdriver or a plastic scribe.
9
Remove the plastic battery-latch assembly starting from the right side
corner and proceeding towards the other end as shown above in the
illustrations.
Replacing the Battery Latch Assembly
1
Insert the latch assembly into the channel on the computer base, and press
it into place.
2
Using a small screwdriver, hook the spring over the hook on the computer
base.
3
Place the battery latch release under the computer base and line it up with
the plastic clips in the base.
Ensure that the newly installed latch moves smoothly and freely when
pushed and released.
1 spring 2 battery latch assembly
3 plastic clips
To Next Page
Loading...
