Dell XPS M1530 - Removing the DIMM B Memory Module

20 Memory
NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing
the cover to close may damage your computer.
3 Replace the module cover.
4 Insert the battery into the battery bay, or connect the AC adapter to your
computer and an electrical outlet.
5 Turn on the computer.
As the computer boots, it detects the additional memory and automatically
updates the system configuration information.
To confirm the amount of memory installed in the computer, click Start
→
Help and Support → Dell System Information.
Removing the DIMM B Memory Module
NOTICE: If a memory module is installed in the DIMM A connector, remove it prior
to removing the memory module from the DIMM B connector. Failure to do so could
result in damaging both memory modules.
1 Follow the procedures in "Before You Begin" on page 9.
2 Turn the computer over and loosen the four captive screws along with the
M2.5 x 5-mm screw. Remove the module cover.
1 tab 2 notch
1 2