Display Assembly 63
12
Display Assembly
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the
Product Information Guide
.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
Removing the Display Assembly
1
Follow the instructions in "Before You Begin" on page 9.
2
Remove the Hinge Covers and the Center Control Cover (see "Removing
the Hinge Covers and Center Control Cover" on page 45).
3
Turn the computer upside down and loosen the four captive screws along
with the M2.5 x 5-mm screw. Remove the memory module cover.
To Next Page
Loading...
