94 ExpressCard Reader
6
Pull up on the ExpressCard reader to disconnect it from the system board.
Replacing the ExpressCard Reader
1
Replace the ExpressCard reader.
2
Replace the three M2 x 3-mm screws that secure the ExpressCard reader to
the computer base.
3
Replace the palm rest (see "Replacing the Palm Rest" on page 79).
4
Replace the display assembly (see "Replacing the Display Assembly" on
page 67).
5
Reinstall the ExpressCards in the ExpressCard slot, if any.
1 M2 x 3-mm screws (3) 2 ExpressCard reader