56 Keyboard
5
Pull up on the plastic bar that secures the keyboard cable to the system
board and remove the keyboard
Replacing the Keyboard
1
Slide the keyboard cable connector into the slot until it clicks and pull
down on the plastic bar that secures the keyboard cable to the system
board.
2
Align the five tabs along the bottom of the keyboard and slide them under
the palm rest.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-
consuming to replace. Be careful when removing and handling the keyboard.
3
Replace the two M2.5 x 5-mm screws along the top of the keyboard.
1 M2.5 x 5-mm screw (2) 2 keyboard
3 keyboard tab (5) 4 keyboard cable
5 plastic securing bar
To Next Page
Loading...
