11. If you are programming over an existing program that has more segments than
the current program you are entering, at the beginning of the next segment,
Press (Decrease) button to change the rate to 0
12. Press (Program) button to program the change, and the display will prompt Strt.
13. Press (Program) button to start the kiln.
14. Press (Program) button and the display will show –On- and begin firing. Note: If
you accidentally selected the wrong program or would like to stop the program,
press (Program) button again and the display will show Stop.
Once the kiln has completed firing, the display will show CPLt and this message will
alternate with the temperature display and the total firing time from start to finish. DO
NOT open the kiln until it has completely cooled and the temperature shows room
temperature.
To Next Page
Loading...