A - BandSawwLh56q/8Blade
B- Table
C - Tablealigningscrew_washer,ana
Wingnut
D ° Miter Gage
E _ _2) Adjusting Wrenches - 3ram and
4ram
F _ Table locking handle and washer
Fig. 2
ASSEMBLY INSTRUCTIONS
. Locate table locking handle assembly (A) Fig. & flat
washer _B), and wrench/C;
stuc tG} Do not lose spring (E).
3. Place table (H) Fig 4: onto band saw frame, making
sure me blade (J) t[avels through the slot (K) in the table
as shown-
4. Make sure the mou r_t_ngrib on the band saw frame is
engaged with the groove on the inside of the table trunnion
_L) Fig. 5,
5, Place fiat washer (B) Fig, 5, on the threaded end of
stud tG'_ and fasten t&ble assembly (H_ to frame using
stud (G_,as shown.
Fig. 3
Fi£ 4
Fig. 5
To Next Page
Loading...
Need help?
General
