39
MAKING ADJUSTMENTS
USING THE MITER GAUGE
USING THE REAR OUTFEED SUPPORT
There are two miter gauge grooves. one on either side of the blade. When making a 90º cross cut, use either groove. For
beveled cross cut use the groove on right so that the blade is tilted away from miter gauge and hands.
Loosen the miter gauge lock knob. Rotate the gauge until desired angle on scale is reached. Retighten lock knob.
See Figure 52.
The out-feed support slides out to provide additional support for cutting long work pieces.
Ensure the power switch is in the OFF position. From the rear of the saw, grasp the out-feed support with both hands
until it is fully extended.
See Figure 53.
FIGURE 52
LOCK
KNOB
FIGURE 53
To Next Page
Loading...
