40 41
MAKING ADJUSTMENTS
USING THE RIGHT HAND TABLE EXTENSION
RIP FENCE ADJUSTMENTS
The table extension, located on the right side of the table, enables you to increase the width of the saw table to
accommodate oversized workpieces.
To use the table extension, refer to Figure 54 and do the following:
Release the table extension lock (B) by moving it up. Slide side table extension out to the right. Use the blue pointer on
the top scale to determine desired distance. When extension table is set to desired width, push lock lever to the lock
position.
To adjust rip fence so it is parallel to the blade, make adjustments to the set screws on the front of the fence as shown in
Figure 55.
FIGURE 54
EXTENSION
TABLE
POINTER
UNLOCK
LOCK
FIGURE 55
HEX
WRENCH
SET SCREW
B
To Next Page
Loading...
