Delta 36-6023 - Making Adjustments; Using the Miter Gauge

MAKING ADJUSTMENTS
LOCK
KNOB
FIGURE 43
USING THE MITER GAUGE
There are two miter gauge grooves, one on either side of the blade, maximum 30°. When making a 90º cross cut, use either
groove. For beveled cross cut use the groove on right so that the blade is tilted away from miter gauge and hands.
Loosen the miter gauge lock knob. Rotate the gauge until desired angle on scale is reached. Retighten lock knob.
See Figure 43.
35