MAKING ADJUSTMENTS
FIGURE 52
FIGURE 53
Adjusting Rail System
Engaging Work Piece Support
• Lift rail lever lock to unlock position.
• Rotate extension knob until the desired cutting dimension is achieved.
• Push rail lever lock down to engage the lock.
See Figure 52.
When working with large pieces of material that extend beyond the table surface flip the work piece support towards the blade side
of the table to provide proper support.
• Locate work piece support on right side of fence.
• Push up on work piece support to ip.
• Flip workpiece support over fence toward the blade side of table.
• Slide workpiece support into place on left side of fence until it is in line with the table.
See Figure 53.
40 41
To Next Page
Loading...
