Delta 36-6023 - Riving Knife Position and Alignment; Vertical Alignment

RIVING KNIFE POSITION AND ALIGNMENT
a
FIGURE 58
VERTICAL ALIGNMENT
The plane of the riving knife appears to be twisted in comparison to the plane of the blade from the bottom of the riving knife to top
of the riving knife. (Can be seen looking from the front of the saw.)
If the riving knife has vertical misalignment, adjust as follows using Figure 55 and Figure 58.
1. Loosen the two hex socket head screws (AA)
2. Make adjustments to (BB2) and (BB3), to align riving knife to the blade. No adjustment is needed for (BB1).
3. Tighten screws (AA).
43