Delta AH Series User Manual

AH Motion Controller – Operation Manual
7-32
_7
After the parameters are set, click OK and the E-CAM editing window will be displayed as below.
E-CAM curve area: the E-CAM curves of position, velocity and acceleration are established according to the specified
data in the Data setting area. You can modify the curves by moving the data points directly in the E-CAM chart, or insert
data points or sections by using function buttons.
Data setting area: By using function buttons, you can create or delete data points or sections and modify the curves by
specifying the data points in the Data setting area. The changes in the data settings area will be synchronized to the
E-CAM curve area.
After the E-CAM item is created, you can right-click on the item and select Delete to delete this item, or select Property to
change the name and password of this E-CAM item. Note that Item ID is not allowed to be changed. Refer to the diagram
below.

Delta AH Series Specifications

General

Brand	Delta
Model	AH Series
Category	Controller
Language	English