Delta AH Series

AH Motion Controller – Operation Manual
9-66
_9
Error Code
Description
Corrective action
16#9B35
An error occurs when COM2
communicates with slave 21 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B36
An error occurs when COM2
communicates with slave 22 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B37
An error occurs when COM2
communicates with slave 23 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B38
An error occurs when COM2
communicates with slave 24 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B39
An error occurs when COM2
communicates with slave 25 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B3A
An error occurs when COM2
communicates with slave 26 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B3B
An error occurs when COM2
communicates with slave 27 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B3C
An error occurs when COM2
communicates with slave 28 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B3D
An error occurs when COM2
communicates with slave 29 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B3E
An error occurs when COM2
communicates with slave 30 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B3F
An error occurs when COM2
communicates with slave 31 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.
16#9B40
An error occurs when COM2
communicates with slave 32 by
MODBUS.
1. Check the communication setting between the connecting
devices.
2. Check if the communication cable is damaged.