Chapter 8 Operation
43
Press and hold the button
for 3 seconds and release it
after you hear one beep.
In Progress...
Self Diagnosis
75%
ONLINE
X
Battery Test Fail
0x1012
!
100
75
%
%
BYPASS
1
Input
Output
232.0V
232.0V
50.0Hz
50.0Hz
4
Once the UPS runs normally, switch on the output protective device (see
)LJXUH
) installed between the UPS and the loads.
z
Start-up with Battery (Cold-start)
1
Please check the ‘+’and ‘-’ poles of the batteries and ensure that wiring is
correct.
2
Turn on the battery breaker.
3
When there is no AC input, press and hold the
ON/ OFF
button
(
)
for 3
seconds to start up the UPS. Release the button after you hear one beep
and the UPS will start up. After the UPS performs self-diagnosis, the UPS
will run in
BATTERY
mode.
To Next Page
Loading...
Need help?
General