Delta ASD-A2R-1B43 Series User Manual

Chapter 12 Setting of Motor Parameters ASDA-A2R Series
Revision December, 2014
12-3
STEP 3: Setup the parameter initial value
This page is for setting up the initial value of parameter editing.
1. Set default value as edit settings: the initial value of parameter editing = The initial value
of the parameter
2. Load from servo as edit settings: the initial value of parameter editing = Servo parameter
value
3. To maintain the current value as edit settings: the initial value of parameter editing = The
parameter value edited in STEP 2.
1
2
3

Delta ASD-A2R-1B43 Series Specifications

General

Brand	Delta
Model	ASD-A2R-1B43 Series
Category	Servo Drives
Language	English