Delta CP2000 Series User Manual

Chapter 1 IntroductionCP2000
1-4
1-4 Apply After Service by Mobile Device
1-4-1 Location of Service Link Label
Frame A–H
Service link label (Service Label) will be pasted on the upper-right corner of the side where keypad
is installed on the case body, as below drawing shown:
Figure 1-2
1-4-2 Service Link Label
Scan QR Code to apply
1. Find out the QR code sticker (as above shown).
2. Using a Smartphone to run a QR Code reader APP.
3. Point your camera to the QR Code. Hold your camera steady so that the QR code comes into
focus.
4. Access the Delta after Service website.
5. Fill your information into the column marked with an orange star.
6. Enter the CAPTCHA and click “Submit” to complete the application.
Cannot find out the QR Code?
1. Open a web browser on your computer or smart phone.
2. Key in https://service.deltaww.com/ia/repair in address bar and press enter.
3. Fill your information into the columns marked with an orange star.
4. Enter the CAPTCHA and click “Submit” to complete the application.
Figure 1-3

Delta CP2000 Series Specifications

General

Output Voltage	0 ~ Input Voltage
Communication Interface	RS-485
Storage Temperature	-20°C to 60°C
Input Voltage	200-240V AC, 380-480V AC
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit