Maintenance
Maintenance Manual 35
5. Slide the safety cover until the slits in the cover are flush with the extension rods. The extension
rods must have access to pass through the slits without interference.
6. Grasp the safety cover and carefully slide it out through the extension rods. Pay attention to the
position of the extension rods to avoid the possibility of injury.
Figure 41. Sliding out the Safety Cover
WHEN SERVICING THE SAFETY COVER MAKE SURE TO KEEP AWARENESS OF THE EXTENSION
R
ODS. CAUTION IS RECOMMENDED TO AVOID INJURY OR DAMAGE WHEN THE EXTENSION RODS
ARE PROTRUDING FROM THE CABINET.
!
To Next Page
Loading...
