Maintenance
Maintenance Manual 43
Installing an Emergency Stop Switch
1. Open the front door if it isn’t open already. See “Opening a Front Door” on page 20. To install an
emergency stop switch, you will need to access the front and rear side of the front door.
2. While facing the external side the front door, locate the housing for the emergency stop switch.
3. Hold the plunger mechanism and align it so that the CN marking faces upwards and the plunger
faces outwards in order to setup the proper alignment. See the following figure for further
details.
4. Insert the barrel mechanism through the opening on the housing until it comes to a stop. The
rubber ring in the middle of the mechanism should be flush in the opening of the housing.
Figure 55. Inserting a Switch Mechanism in its Housing
To Next Page
Loading...
