Maintenance
Maintenance Manual 49
Removing a DC-Side Fan Module
The fan module is located on the DC side of the enclosure. In order to reach the fan assembly, you
must first open the safety cover.
1. Open the front door. See “Opening a Front Door” on page 20.
2. Remove the safety cover. See “Removing a Safety Cover” on page 34.
3. Locate the cable tray, see the following figure, with the end cap (top). Press the sides of the tray
walls to unlock the end cap.
4. While holding the sides in, lift the end cap to remove it. Once the cap is removed, the fan cables
are exposed for servicing.
Figure 62. Removing an End Cap from a Cable Tray
5. Separate the cable ends to disconnect the fan assembly.
Figure 63. Disconnecting a DC-side Fan Assembly
To Next Page
Loading...
