Maintenance
Maintenance Manual 52
8. Hold the cable attached to the fan module and insert it in the channels of the cable tray. Make
sure the head of the cable sits in the middle of the cable tray.
9. Locate the remaining cable end and connect it to the cable already inserted in the channel.
10. Once connected, lower the unsecured cable through into the tray. Make sure there is no excess
cable outside of the cable tray.
11. Tuck any excess cable in the tray.
Figure 68. Connecting a Fan Module Cable
12. Place the end cap over the tray and press it in to secure. Make sure the cover is flush in the tray.
No part of the cover should extend past the sides of the tray.
Figure 69. Installing a Bracket Cover
13. Install the safety cover. See “Installing a Safety Cover” on page 37.
14. Close the front door. See “Closing a Front Door” on page 22.
To Next Page
Loading...
