Delta R2-EC 004 Series - Wiring Requirements

Wiring and Installation R2-ECx004 User Manual
3-8
3
(3) The installation is complete.
DIN
3.4.2 Wiring requirements
1. The recommended wire gauge for wiring with the housing connector or terminal block is
26 to 18 AWG.
2. The recommended length for exposed wire is 8 mm to 9 mm (0.31” to 0.35”).
3. Pay attention to the following when wiring with wire ferrules.
 Use a correct crimping tool (such as Dinkle DNT13-0101).
 The recommended length for L1 is 8 mm to 10 mm (0.31” to 0.39”).
 The recommended diameter (D1) is 0.75 mm to 1.4 mm (0.03” to 0.06”).
L1
D1 (Φ)