104
The number of cycles used to calculate the rate at which frequency change rate protection is
used.
4.3.6.2.3 Number of Valid
It is the number of controls used to calculate speed in frequency change rate protection.
4.3.6.2.4 Inhibit>20 Hz/s
It is the setting used to prevent protection when the speed is above 20 Hz / s in frequency
change rate protection. If it is active, it will block; if it is passive, there will be no
intervention. This can prevent the protection from being triggered in the wrong
measurements.
4.4 Automatic controlHata!
4.4.1 46BC – Broken Conductor
Under Construction
4.4.2 94/86 – Output / Relay Trip Setting
Under Construction
4.4.3 Trip Settings
Under Construction
4.4.4 Output Settings
Under Construction
4.4.5 Input Settings
Under Construction
4.4.6 Custom Input / Timer Relay
Under Construction
To Next Page
Loading...
Need help?
General
