70
poles in a distribution center and opening of the breaker, stopping the engine in the event that
the water supply of a water pump is depleted.
In order for the phase low current protection function works properly, any of the
programmable inputs must be assigned the 52a function.
Phase Undercurrent Protection is indicated by I< in IEC 60617 Standards; PHI_PIUC in IEC
61850 Standards; 37P-I in IEEE/ANSI Standards
Phase Undercurrent Protection Function Values
The menu view is as follows.
The settings that can be made in the menu are described below.
4.3.2.6.1 Protection
activated in the active state and disabled in the passive state.
To Next Page
Loading...
Need help?
General
