To Next PageTo Next Page
Why is there no sound from surround back speaker on my Denon Stereo Receiver?
Ensure the pre-out assignment for the surround back speakers is correctly set. Verify that the “S.Back” setting is not set to “None.” Check that the “Parameter” – “Surround Parameter” – “SB CH Out” settings are not “OFF.” Finally, select a surround playback mode that supports 6.1- or 7.1-channel playback.
Why is there no sound from the subwoofer on my Denon Stereo Receiver?
First, ensure the subwoofer is powered on. Check that the “Subwoofer” setting at “Speaker Config.” is set to “Yes.” Verify the connections to the subwoofer are correct. Finally, adjust the subwoofer’s volume to an appropriate level, ensuring it’s not turned off.
How to fix no sound from surround speakers on Denon Stereo Receiver?
If the surround mode is set to “STEREO” or “DIRECT”, change it to a surround playback mode.
How do I fix no sound from the center speaker on my Denon Stereo Receiver?
If you are playing a monaural source in “STANDARD” mode, change the mode to something other than “STANDARD” (Dolby/DTS Surround).
General| Channels | 5.1 |
|---|---|
| Power Output | 75 W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
| HDMI Inputs | 4 |
| HDMI Outputs | 1 |
| Signal-To-Noise Ratio | 98 dB |
| THD | 0.08% |
| Input Impedance | 47 kOhm |
| Input Sensitivity | 200 mV |
| Surround System Class | 5.1 channel |
| HDMI Switching | Yes |
| 3D Technology | Yes |
| Input Sensitivity/Impedance | 200 mV / 47 kOhm |
| HDMI Version | 1.3a |
| Dolby Formats | Dolby Digital, Dolby Digital Plus |
| DTS Formats | DTS, DTS Neo:6, DTS 96/24 |
| Audyssey | MultEQ |
| Amplifier Output Details | 75 W per channel at 8 ohms, 20 Hz to 20 kHz, 0.08% THD |
| Response Bandwidth | 10Hz - 100kHz |
| Audio D/A Converter | 192 kHz/24-bit |
| Frequency Response | 10 Hz to 100 kHz |
| Video Inputs/Outputs | Composite, Component |
| Audio Inputs/Outputs | Digital Optical |
