EasyManuals Logo

Denon AVR-1707 Service Manual

Denon AVR-1707
131 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
AVR-1707/1507/687/587/487
VIDEO Section (AVR-1707/687 ONLY)
1. SETTING
(1) Connect the oscilloscope to the Y-signal and C-signal of
S MONITOR OUT terminal and each terminate at 75
Ohms.
(2) Connect the oscilloscope to the Y-signal, P
B-signal and
C
B-signal, PR-signal and CR-signal of COMPONENT
MONITOR OUT terminal and each terminate at 75
Ohms.
Use the 75 Ohms resistance must be 1%
(3) DVD test disc : DVDT-S01
(4) COMPOSITE VIDEO OUT of DVD player is connected
to COMPOSITE : DVD.
2. BEFORE ADJUSTMENT
2.1. Setting the Oscilloscope as below.
(1) PB/CB, PR/CR, C
(a) TIME/DIV : 10μs
(b) VOLT/DIV : 100mV
(Use the probe : x10 )
(2) Y (Py)
(a) TIME/DIV : 10μs
(b) VOLT/DIV : 200mV
(Use the probe : x10 )
Power on. Power Supply
U.S.A. , Canada & Taiwan R.O.C. : 120V
Europe : 230V
Japan : 100V
China & Korea : 220V
2.2. Setup the DVD player and confirmation of the
stators
(1) Set to "INTERLACED" mode at the COMPONENT OUT.
(2) Confirm the DVD player’s out put level is equal as the
item 2.4. in following.
2.3. Preparation
(1) Turn the FUNCTION knob to select "DVD" input.
(2) Push [OPEN/CLOSE] button of DVD player, then open
the Disc Tray.
Set DVD test disc (DVDT-S01) on the Disc Tray, and
then push [CLOSE] button.
(3) DVD player FL display appear "STOP", push [PLAY] but-
ton to playback DVD.
(4) Push the [DISPLAY] button of remote control of DVD
player unit and then appear the ON-Screen Display (GUI)
on the monitor TV.
(5) Push the [+10] and [2] button, select Title 12 of DVD.
(6) Push the [ENTER] button, playback Title 12.
(color bar 75%)
ビデオセクション(AVR-1707/687 のみ )
1. セッティング手順
(1) セットの SMONITOROUT 端子から Y 信号と C 信号を
それぞれオシロスコープ(終端抵抗:75Ω)に接続し
ます。
(2) セットのCOMPONENTMONITOROUTの端子
(Y,P
B/CB,PR/CR)をそれぞれオシロスコープ
(終端抵抗:75Ω)に接続します。
※ 75Ω 抵抗は 1%品を使用する事。
(3) DVD テストディスク:DVDT-S01 を用意します。
(4) DVD プレーヤーの COMPOSITEVIDEOOUT
COMPOSITE:DVD に接続します。
(5)
2. 調整のまえに
2.1. オシロスコープを下記に設定
(1) PB/CB,PR/CR,C
(a) TIME/DIV : 10μs
(b) VOLT/DIV : 100mV
(プローブ x10 使用)
(2) Y(Py)
(a) TIME/DIV : 10μs
(b) VOLT/DIV : 200mV
(プローブ x10 使用)
電源電圧
U.S.A. , Canada & Taiwan R.O.C. : 120V
Europe : 230V
Japan : 100V
China & Korea : 220V
2.2. DVD プレーヤの設定と確認
(1) COMPONENTOUT の設定を " インターレース " にしま
す。
(2) DVD プレーヤーの出力が以下 2.4. に合っていることを
確認します。
2.3. 準備手順
(1) FUNCTION ノブを回し、入力を "DVD" に切り替えます。
(2) DVD プレーヤーの「OPEN/CLOSE」ボタンを押しトレ
イを開き、トレイ上に DVD テストディスク(DVDT-
S01)をセット後、「CLOSE」ボタンを押します。
(3) DVD プレーヤーの表示管上に "STOP" が表示されてか
ら、「PLAY」ボタンを押し、ディスクを再生します。
(4) DVD プレーヤーのリモコンの「DISPLAY」ボタンを押
しグラフィカル・ユーザー・インターフェイス (GUI)
面を出します。
(5) 番号ボタンの +10 , 2 」ボタンを押し、Title12 を選択
します。
(6) 「ENTER」ボタンを押し、Title12 を再生します。
(75%カラーバー信号)

Table of Contents

Other manuals for Denon AVR-1707

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1707 and is the answer not in the manual?

Denon AVR-1707 Specifications

General IconGeneral
Speakers connectivity type-
Receiver typeSurround
Frequency range10 - 100000 Hz
Audio output channels7.1 channels
Audio A/D Converter (ADC)24-bit/96kHz
Total Harmonic Distortion (THD)0.7 %
Power output per channel (1KHz@6 Ohm)110 W
Power output per channel (20-20KHz@8 Ohm)75 W
Product colorSilver
Audio decodersDTS, DTS 96/24, DTS Neo:6, DTS-ES (Discrete 6.1), DTS-ES (Matrix 6.1), Dolby Digital, Dolby Digital EX, Dolby Pro Logic II, Dolby Pro Logic IIx
Apple docking compatibilityiPod
Digital Signal Processing (DSP)Yes
HDMI in0
Digital audio optical in2
Component video (YPbPr/YCbCr) in3
Optical drive includedNo
Weight and Dimensions IconWeight and Dimensions
Depth417 mm
Width434 mm
Height147 mm
Weight11400 g

Related product manuals