ENGLISH FRANCAIS
oSAFETY PRECAUTIONS
SAFETY INSTRUCTIONS
13.
Power-Cord Protection - Power-supply cords should be routed so that they
are
not
likely
to
be walked on or pinched by
items
placed upon or against
them, paying particular attention
to
cords
at
plugs, convenience receptacles,
and
the
point
where
they exit
from
the
product.
14.
Outdoor Antenna Grounding - If
an
outside antenna or cable system is
connected
to
the product, be sure
the
antenna or cable system
is
grounded
so
as to provide
some
protection against voltage surges and built-up static
charges. Article 810
of
the National Electrical Code, ANSI/NFPA 70, provides
information
with
regard to proper grounding
of
the mast and supporting
structure, grounding
of
the lead-in
wire
to
an
antenna discharge unit, size
of
grounding conductors, location
of
antenna-discharge unit, connection
to
grounding electrodes, and requirements for the grounding electrode. See
Figure
A.
15. Lightning -
For
added protection for this product during a lightning storm,
or
when
it
is lett unattended and unused for long periods
of
time, unplug
it
from
the wall outlet and disconnect
the
antenna
or
cable system. This
will
prevent damage
to
the product due
to
lightning and power-line surges.
16.
Power Lines - An outside antenna system should
not
be located
in
the
vicinity
of
overhead
power
lines or other electric light or power circuits,
or
where
it can fall into such
power
lines or circuits.
When
installing
an
outside
antenna system,
extreme
care should be taken
to
keep from touching such
power
lines or circuits
as
contact
with
them
might
be fatal.
17. Overloading - Do
not
overload wall outlets, extension cords, or integral
convenience receptacles
as
this can result in a risk
of
fire or electric shock.
18.
Object and Liquid Entry - Never push objects
of
any kind into this product
through openings
as
they may touch dangerous voltage points or short-out
parts that could result
in
a fire or electric shock. Never spill liquid
of
any kind
on
the
product.
19. Servicing - Do
not
attempt
to
service this product yourself
as
opening
or
removing covers may expose you
to
dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
20. Damage Requiring Service - Unplug this product from the wall
outlet
and refer servicing
to
qualified service personnel under the following
conditions:
a)
When
the power-supply cord or plug
is
damaged,
b)
If liquid has been spilled, or objects have fallen into the product,
cI
If the product has been exposed
to
rain
or
water,
dl If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating
instructions
as
an
improper
adjustment
of
other controls may result in
damage and will otten require extensive
work
by a qualified technician
to
restore the product
to
its normal operation,
e)
If
the product has been dropped or damaged in any way, and
f)
When
the product exhibits a distinct change in performance - this
indicates a need for service.
21. Replacement Parts -
When
replacement parts are required, be sure the
service technician has used replacement parts specified by the manufacturer
or
have the same characteristics as
the
original part. Unauthorized
substitutions may result in fire, electric shock, or other hazards.
22. Safety Check - Upon completion
of
any service or repairs to this product,
ask the service technician
to
perform
safety checks to determine that the
product
is
in proper operating condition.
23. Wall
or
Ceiling
Mounting
- The product should be mounted
to
a wall or
ceiling only
as
recommended by
the
manufacturer.
24. Heat - The product should be situated away from heat sources such
as
radiators, heat registers, stoves, or other products !including
amplifierslthat
produce heat.
ANTENNA
LEAD
IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEe
SECTION 810.20)
2.
1.
3.
4.
5
7
6.
___
POWER
SERVICE
GROUNDING
ELECTRODE SYSTEM
NEe·
NATIONAL ELECTRICAL CODE
(NEe
AAT 250. PART H)
8.
9.
Read
Instructions - All
the
safety and operating instructions should be read
before the product is operated.
Retain Instructions - The safety and operating instructions should be
retained for future reference.
Heed Warnings - All warnings on the product and in the operating
instructions should be adhered to.
Follow Instructions - All operating and use instructions should be followed.
Cleaning - Unplug this product
from
the wall outlet before cleaning. Do
not
use liquid cleaners or aerosol cleaners.
Attachments - Do
not
use attachments
not
recommended by the product
manufacturer as
they
may cause hazards.
Water and
Moisture
- Do
not
use this product near
water
-
for
example,
near a bath tub,
wash
bowl, kitchen sink, or laundry tub; in a
wet
basement;
or near a
swimming
pool; and
the
like.
Accessories - Do
not
place this product on
an
unstable cart, stand, tripod,
bracket, or table. The product may fall, causing serious injury
to
a child or
adult, and serious damage
to
the product. Use only
with
a cart, stand,
tripod, bracket, or table
recommended
by
the
manufacturer, or sold
with
the
product. Any
mounting
of
the
product should
follow
the manufacturer's instructions, and should
use a
mounting
accessory
recommended
by the
manufacturer.
A product and cart combination should be moved
with
care. Quick stops, excessive force, and
uneven surfaces may cause the product and cart
combination
to
overturn.
10
Ventilation - Slots and openings in the cabinet are provided for ventilation
and
to
ensure reliable operation
of
the
product and
to
protect
it
from
overheating, and these openings
must
not be blocked or covered. The
openings should never be blocked by placing the product on a bed, sofa,
rug, or
other
similar surface. This product should not be placed
in
a built-in
installation such as a bookcase or rack unless proper ventilation
is
provided
or the manufacturer's instructions have been adhered to.
n Power Sources - This product should be operated only from the type
of
power
source indicated on
the
marking label. If you are not sure
of
the
type
of
power supply
to
your home, consult your product dealer or local
power
company. For products intended
to
operate from battery power, or
other
sources, refer to
the
operating instructions.
12.
Grounding or Polarization - This product may be equipped
with
a polarized
alternating-current line plug la plug having one blade
wider
than
the
other).
This plug
will
fit into the
power
outlet
only one way. This
is
a safety feature.
If you are unable
to
insert the plug fully into the outlet,
try
reversing
the
plug.
If
the
plug should still fail
to
fit, contact your electrician
to
replace your
obsolete outlet. Do
not
defeat
the safety purpose
of
the
polarized plug.
The lightning flash
with
arrowhead symbol,
within
an
equilateral
triangle,
is
intended
to
alert
the
user
to
the presence
of
uninsulated "dangerous voltage"
within
the
product's enclosure
that
may be
of
sufficient magnitude
to
constitute a risk
of
electric
shock
to
persons.
The exclamation point
within
an
equilateral triangle is intended
to
alert
the
user to the presence
of
important
operating
and maintenance (servicing) instructions
in
the
literature
accompanying
the
appliance.
CAUTION:
TO
REDUCE
THE
RISK
OF
ELECTRIC
SHOCK,
DO
NOT
REMOVE
COVER
(OR
BACK).
NO
USER·SERVICEABLE
PARTS
INSIDE.
REFER
SERVICING
TO
QUALIFIED
SERVICE
PERSONNEL.
WARNING:
TO
REDUCE
THE
RISK
OF
FIRE
OR
ELECTRIC
SHOCK,
DO
NOT
EXPOSE
THIS APPLIANCETO
RAIN
OR
MOISTURE,
I
To Next Page
Loading...
Need help?
General
Weight and Dimensions
