Denon AVR-1913 - SCHEMATIC DIAGRAMS (15;26); 7 CH-AMP UNIT (1;2)

136
Surround
Sound Mode (vpage67)
NOTE
Input signal types and formats
ANALOG
PCM DTS-HD DTS DOLBY DOLBY DIGITAL
PCM
(multi ch)
PCM
(2ch)
DTS-HD
Master Audio
DTS-HD High
Resolution
Audio
DTS
EXPRESS
DTS ES
DSCRT
(With Flag)
DTS ES
MTRX
(With Flag)
DTS
(5.1ch)
DTS 96/24
DOLBY
TrueHD
DOLBY
DIGITAL Plus
DOLBY
DIGITAL EX
(With Flag)
DOLBY
DIGITAL EX
(With no
Flag)
DOLBY
DIGITAL
(5.1/5/4/3ch)
DOLBY
DIGITAL
(2ch)
MULTI CH IN
MULTI CH IN
F
MULTI CH IN + PLgx CINEMA z1z3 S
MULTI CH IN + PLgx MUSIC z1z2 S
MULTI CH IN + PLgz z1z4 S
MULTI CH IN + Dolby EX
z1z2 S
MULTI CH IN 7.1
z1z2 F (7.1)
DIRECT
DIRECT
S S S S S S S S S S S S S S S S
PURE DIRECT
PURE DIRECT
S S S S S S S S S S S S S S S S
DSP SIMULATION
MULTI CH STEREO
S S S S S S S S S S S S S S S S
ROCK ARENA
S S S S S S S S S S S S S S S S
JAZZ CLUB
S S S S S S S S S S S S S S S S
MONO MOVIE
S S S S S S S S S S S S S S S S
VIDEO GAME
S S S S S S S S S S S S S S S S
MATRIX
S S S S S S S S S S S S S S S S
VIRTUAL
S S S S S S S S S S S S S S S S
STEREO
STEREO
F S F S S S S S S S S S S S S S
z1 This sound mode can be selected when “Amp Assign” (vpage113) is set to “Surround Back”.
z2 If “Speaker Config.” – “Surr. Back” (vpage113) is set to “None”, this sound mode cannot be selected.
z3 If “Speaker Config.” – “Surr. Back” (vpage113) is set to “1spkr” or “None”, this sound mode cannot be selected.
z4 If “Speaker Config.” – “Front Height” (vpage114) is set to “None”, this sound mode cannot be selected.
Basic version
Advanced version
InformationInformation