Why is there no sound from my subwoofer connected to my Denon Stereo Receiver?
If you're not hearing sound from your subwoofer with your Denon Stereo Receiver, first ensure the subwoofer is powered on. Check the 'Subwoofer' setting in 'Speaker Configuration' and make sure it is set to 'Yes'. Verify that the subwoofer is properly connected. Also, ensure that the subwoofer's volume is turned up to an appropriate level.
General| Type | AV Receiver |
|---|---|
| Number of channels | 7.1 |
| Total Harmonic Distortion | 0.08 % |
| Input Sensitivity | 200 mV |
| Signal-to-Noise Ratio | 100 dB |
| Tuner Type | AM/FM |
| HDMI Inputs | 2 |
| HDMI Outputs | 1 |
| Component video inputs | 3 |
| Component video outputs | 1 |
| Dolby Digital | Yes |
| DTS | Yes |
| Frequency Response | 10 Hz - 100 kHz |
| Video Outputs | composite video x 1, component video x 1 |
| Digital audio inputs | 3 x Optical, 2 x Coaxial |
| Dimensions | 434 x 171 x 414 mm |
| Speaker Impedance | 6-16 Ohm |
Important warnings, safety symbols, and statements of conformity with standards.
Instructions for microphone setup and automatic speaker/room calibration.
Manually setting speaker sizes, distances, and levels.
Configuring HDMI output for audio/video and adjusting audio playback settings.
Adjusting surround sound parameters, tone control, and room EQ.
Steps for turning the unit on/off and choosing an input source.
Setting up the remote to control DENON and third-party audio/video devices.
Solutions for common audio, iPod, video, and picture issues.
To Next Page
