For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 17).
d
Dolby Digital Setup
Set dynamic range for downmix playback of Dolby Digital
sources.
• Set this to “ON” if the sound from the front speakers seems
distorted.
• When not using the center speaker or surround speakers, the
playback sound is down-mixed and output from the front speakers.
f
Auto Surround Mode
Make setting for memorizing surround mode setting for each
input signal type.
• The auto surround mode function lets you store in the memory the
surround mode last used for playing the four types of input signals
listed below.
q Analog and PCM 2-channel signals
w Dolby Digital and DTS 2-channel signals
e Dolby Digital and DTS multi-channel signals
r Multi-channel signals other than Dolby Digital and DTS (PCM,
etc.)
• When playing in the PURE DIRECT mode, the surround mode does
not change even if the input signal is changed.
[Selectable items]
ON
: Memorize settings. Most recently stored surround mode is
automatically selected.
OFF
: Do not memorize settings. Surround mode does not change
according to input signal.
[Selectable items]
ON
: Compression is used. Select this if sound from front
speakers is distorted.
OFF
: Do not use compression. This is the recommended
setting.
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
g
EQ Preset
Set MultEQ related settings and Manual EQ beforehand.
EQ Customize
When MultEQ
®
and Manual EQ you are not using are preset, MultEQ
can be skipped when selected on the main unit or remote control
unit.
n Before running Auto Setup
[Selectable items]
Manual :
Used
Not Used
n After running Auto Setup
[Selectable items]
Audyssey Byp. L/R :
Used
Not Used
Audyssey Flat :
Used
Not Used
Manual :
Used
Not Used
Direct Mode
Select “MultEQ” use for DIRECT or PURE DIRECT mode.
[Selectable items]
ON
: Use “MultEQ”.
OFF
: Do not use “MultEQ”.
Manual EQ
Adjust tonal quality for each speaker using graphic equalizer.
n Default
Resets the settings to the default values.
n Base Curve Copy
Copy the MultEQ “Audyssey Flat” correction curve.
[Selectable items]
Yes
No
n Adjust CH
q Select speaker adjustment method.
[Selectable items]
Each CH
: Adjust tonal quality for each speaker separately.
L/R CH
: Adjust tonal quality for each L/R speaker pair.
All CH
: Adjust tonal quality for all speakers together.
w
Select the speaker and frequency band and adjust the level.
[Selectable items]
63Hz
125Hz
250Hz
500Hz
1kHz
2kHz
4kHz
8kHz
16kHz
[Variable range]
–20dB
~
0dB
~
+6dB
“Base Curve Copy” is displayed after the auto setup procedure has
been performed.
Specifications
To Next Page
Loading...
Need help?
General
