Denon AVR-2309 User Manual

Parameter
[AUDIO DELAY]
[NIGHT]
MULTEQ
RESTORER
DYNAMIC
VOLUME
[SOURCE
CONTROL 1]
uiop
ENTER
ENTER, opRETURNDYNAMIC VOLUME
uiMULTEQ <MENU>RESTORER
uiop
[STD]
RETURN
[MUSIC]
[CINEMA]
[A. MENU]
ENTER
[Front]
[Rear]
Button located on both the main unit and the remote control
unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
1
Press <MENU> or [A.MENU].
The menu is displayed.
b To operate from the remote control unit, be sure to set the
[SOURCE CONTROL 1] to “AUDIO”.
2
Press ui to select “Parameter”, then press ENTER.
3
To change the setting:
Press ui to select the item you want to change, then
press o p to change the setting.
b To return to the previous item, press RETURN.
b Select “Default Yes”, then press o to reset to the default
setting.
4
Press ENTER to enter the setting.
Adjusting the parameters
n To exit adjustment
Press <MENU> or [A.MENU] during adjustment.
Operating from the main unit
Use <SELECT/ENTER> to select the surround mode.
n During PCM (2ch) / Analog / DOLBY DIGITAL (2ch)
DIRECT STEREO
DTS NEO:6
7CH STEREO (5CH STEREO)
MATRIXVIRTUAL
DOLBY PRO LOGIC gx
(DOLBY PRO LOGIC g)
VIDEO GAME
MONO MOVIE
ROCK ARENA
JAZZ CLUB
n During Digital (Multi channel)
DIRECT STEREO
7CH STEREO
(5CH STEREO)
STANDARD
(Dolby Digital, DTS, etc)
MATRIXVIRTUAL
ROCK ARENA
JAZZ CLUB
MONO MOVIE
VIDEO GAME
Playback in the PURE DIRECT Mode
This is the mode that recreates the original sound most faithfully,
providing extremely high quality sound.
• To cancel, press [PURE] again.
• When in the PURE DIRECT mode, the on-screen display is not
displayed and the display on the main unit is turned off.
• If the HDMI input connector is selected, video outputs are output in
the PURE DIRECT mode.
• The channel level and surround parameters in the PURE DIRECT
mode are the same as in the DIRECT mode.
Press [PURE].

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
Specifi cations

Denon AVR-2309 Specifications

General

Number of Channels	7.1
HDMI Inputs	4
HDMI Outputs	1
Dolby Technologies	Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Pro Logic IIx
Auto Calibration	Audyssey MultEQ
Component Video Inputs	3
Analog Audio Inputs	7
Response Bandwidth	10 - 100000 Hz
Signal-To-Noise Ratio	100 dB
THD	0.08%
Input Impedance	47 kOhm
Input Sensitivity	200 mV
Tuner Presets	56
HDMI Switching	Yes
Surround Sound Effects	Yes
Digital Sound Processor (DSP)	Yes
DSP Preset Qty	7
HDMI Pass-Through	Yes
Frequency Response	10 - 100000 Hz
DTS Technologies	DTS-HD Master Audio
Digital Audio Inputs	2 Coaxial
Audio D/A Converter	192kHz/24-bit
Amplifier Output Details	100 Watt - 8 Ohm - 20 - 20000 Hz - THD 0.08% - 7 channel(s)