• To cancel, press <ZONE2/REC SELECT>, then turn <SOURCE
SELECT> until “ZONE2 SOURCE” is displayed.
• Make a test recording before starting the actual recording.
• Sources selected with the REC OUT mode are output from ZONE2
as well.
• In the REC OUT mode, the remote control unit’s ZONE2 mode
buttons cannot be operated.
• The source selected for ZONE2 is output from the digital output
connector (OPTICAL 2).
Recording on an External Equipment
(REC OUT mode)
You can listen to one program source while recording a different
program source.
1
Press <ZONE2/REC SELECT>.
“ZONE2 SOURCE” is shown on the display.
ZONE2 SOURCE ZONE2 TUNER ZONE2 V.AUX····
RECOUT V.AUX RECOUT TUNER RECOUT SOURCE······
2
Turn <SOURCE SELECT> until “RECOUT Source” is
displayed.
The “ ” indicator lights.
3
Turn <SOURCE SELECT> to choose the input source
to be recorded.
4
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
47).
5
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
Other Operations
NOTE
• Digital signals are not output from the analog REC OUT connector.
• Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
• Input sources for which “Delete” is selected at “Source Delete”
cannot be selected.
<SOURCE SELECT>
<ZONE2/REC SELECT>
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Other Operations and Functions
Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
Specifi cations
To Next Page
Loading...
Need help?
General
