Denon AVR-2309 User Manual

Button
Note
Input signals
ANALOG
PCM DTS-HD DTS DOLBY DOLBY DIGITAL
Surround mode
Linear
PCM
(multi ch)
Linear
PCM
(2ch)
DTS-HD
Master
Audio
DTS-HD
High
Resolution
Audio
DTS ES
DSCRT
(With Flag)
DTS ES
MTRX
(With Flag)
DTS
(5.1ch)
DTS
96/24
DOLBY
TrueHD
DOLBY
DIGITAL
Plus
DOLBY
DIGITAL
EX (With
Flag)
DOLBY
DIGITAL EX
(With no
Flag)
DOLBY
DIGITAL
(5.1/5/4ch)
DOLBY
DIGITAL
(4/3ch)
DOLBY
DIGITAL
(2ch)
STANDARD
DTS SURROUND
DTS-HD MSTR
A A A F A A A A A A A A A A A A
DTS-HD HI RES
A A A A F A A A A A A A A A A A
DTS ES DSCRT6.1
z
1
z
4
A A A A A F D A A A A A A A A A A
DTS ES MTRX6.1
z
1
z
4
A A A A A A F D A A A A A A A A A
DTS SURROUND
A A A A A S S F A A A A A A A A
DTS 96/24
A A A A A A A A F A A A A A A A
DTS (–HD) + PLgx CINEMA
z
2
z
4
A A A S S S S S S A A A A A A A
DTS (–HD) + PLgx MUSIC
z
1
z
4
A A A S S S S S S A A A A A A A
DTS (–HD) + NEO:6
z
1
z
4
A A A S S A S S S A A A A A A A
DTS NEO:6 CINEMA
S A S A A A A A A A A A A A A S
DTS NEO:6 MUSIC
S A S A A A A A A A A A A A A S
DOLBY SURROUND
DOLBY TrueHD
A A A A A A A A A F A A A A A A
DOLBY DIGITAL+
A A A A A A A A A A F A A A A A
DOLBY DIGITAL EX
z
1
z
4
A A A A A A A A A A A S S S S A
DOLBY (D+) (HD) +EX
z
1
z
4
A A A A A A A A A S S A A A A A
DOLBY DIGITAL
A A A A A A A A A A A S F F F A
DOLBY (D) (D+) (HD) +PLgx CINEMA
z
2
z
4
A A A A A A A A A S S F D S S S A
DOLBY (D) (D+) (HD) +PLgx MUSIC
z
1
z
4
A A A A A A A A A S S S S S S A
DOLBY PRO LOGIC gx CINEMA
z
4
S A S A A A A A A A A A A A A F
DOLBY PRO LOGIC gx MUSIC
z
4
S A S A A A A A A A A A A A A S
DOLBY PRO LOGIC gx GAME
z
4
S A S A A A A A A A A A A A A S
DOLBY PRO LOGIC g CINEMA S A S A A A A A A A A A A A A S
DOLBY PRO LOGIC g MUSIC S A S A A A A A A A A A A A A S
DOLBY PRO LOGIC g GAME S A S A A A A A A A A A A A A S
DOLBY PRO LOGIC
S A S A A A A A A A A A A A A S
F : Mode selectable in initial status
D : Mode fixed when “AFDM” is “ON”
S : Selectable mode
A : Non-selectable mode
NOTE:
z
1: This mode is not available when the surround back speaker setup is set to “None”.
z
2: This mode is not available when the surround back speaker setup is set to “1spkr” or “None”.
z
4: Cannot be set when “Amp Assign” is set to “ZONE2”.
Differences in Surround Mode Names Depending on the Input Signals

Getting Started Connections Setup Playback Remote Control Multi-zone Information Troubleshooting
ENGLISH
Specifications

Denon AVR-2309 Specifications

General

Number of Channels	7.1
HDMI Inputs	4
HDMI Outputs	1
Dolby Technologies	Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Pro Logic IIx
Auto Calibration	Audyssey MultEQ
Component Video Inputs	3
Analog Audio Inputs	7
Response Bandwidth	10 - 100000 Hz
Signal-To-Noise Ratio	100 dB
THD	0.08%
Input Impedance	47 kOhm
Input Sensitivity	200 mV
Tuner Presets	56
HDMI Switching	Yes
Surround Sound Effects	Yes
Digital Sound Processor (DSP)	Yes
DSP Preset Qty	7
HDMI Pass-Through	Yes
Frequency Response	10 - 100000 Hz
DTS Technologies	DTS-HD Master Audio
Digital Audio Inputs	2 Coaxial
Audio D/A Converter	192kHz/24-bit
Amplifier Output Details	100 Watt - 8 Ohm - 20 - 20000 Hz - THD 0.08% - 7 channel(s)