109
Basic versionSimple version Information
ENGLISH
Advanced version
Erasing the code by each equipment input source
1
Press and hold POWER ON and
ZONE/DEVICE ON for at least 3
seconds.
“SETUP” flashes twice on the remote
control unit.
2
Use ui to display “RESET” on
the remote control unit and press
ENTER.
3
When “LEARN” appears on the
remote control unit, press ENTER.
4
When “MODE?” appears on the
remote control unit, press the
input source select button of the
AV equipment that you want to
erase.
5
When “ALL?” appears, press ENTER.
“RESET” flashes four times on the remote control unit and the
normal operation mode is restored.
Operating the main remote control unit
Operating macro function
• When the macro function is used, operations that usually require a
complicated series of multiple button operations can be performed
easily just by pressing the MACRO button.
• This device can remember up to 3 macro functions.
• Each macro can record a maximum of 18 steps.
[Example] All system power on
q Turn the TV’s power on
↓
w Turn this unit’s power on
↓
e Switch this unit’s input source to DVD
↓
r Turn the DVD’s power on
n Recording macro operations
1
Press and hold POWER ON and ZONE/DEVICE ON
for at least 3 seconds.
“SETUP” flashes twice on the remote control unit.
2
Use ui to display “MACRO”
on the remote control unit and
press ENTER.
3
When “MCNo? ” appears on the
remote control unit, press the
QUICK SELECT button that you
want to store.
Button Macro number
QUICK SELECT 1 MACRO-1
QUICK SELECT 2 MACRO-2
QUICK SELECT 3 MACRO-3
4
Press the buttons to be stored one
by one.
• The step number for the storing procedure and mode are alternately
displayed on the remote control unit.
• You cannot store the macros for the ZONE SELECT, SOURCE
SELECT
and BACK LIGHT buttons.
5
Press MACRO to exit the macro function.
“SET” flashes four times on the remote control unit and the
normal operation mode is restored.
n Adjusting the interval time of macro operations
transmitting
The macro operation transmission interval can be adjusted.
• The factory setting is “0.5 sec”.
1
Press and hold POWER ON and
ZONE/DEVICE ON for at least 3
seconds.
“SETUP” flashes twice on the remote
control unit.
2
Use ui to display “MACRO”
on the remote control unit and
press ENTER.
3
When “MCNo?” appears on the
remote control unit, press the
QUICK SELECT button that you
want to set.
Button Macro number
QUICK SELECT 1 MACRO-1
QUICK SELECT 2 MACRO-2
QUICK SELECT 3 MACRO-3
4
Press MACRO many times to set the macro operation
transmission interval and press ENTER.
“SET” flashes four times on the remote control unit and the
normal operation mode is restored.
Remote control unit display
Time values that you can
set
0.25 0.25 sec
0.50 0.5 sec
0.75 0.75 sec
1.00 1 sec
1.25 1.25 sec
1.AVR4311E2_ENG_6th_0810.indd 109 2010/08/12 10:12:21
To Next Page
Loading...
Need help?
General
