22
Setting the THX Surround EX / DTS-ES Source Auto
Set the operation for the digital signals when playing in the 6.1 SURROUND, DTS-ES and THX SURROUND EX surround modes.
1
At the System Setup Menu select “SB CH Auto Flag
Detect” and press the ENTER button.
2
Select the desired setting.
When set to “ON”, the
operation for software for which
no identification signals are
recorded is set.
3
Enter the setting.
The System Setup Menu reappears.
THX surround EX/DTS ES Auto Flag Detect Mode (AFDM) setting
ON .................This function only works with software on which a special identification signal is recorded.
This is a function for automatically playing in the 6.1-channel mode using the surround back speakers if the software is recorded
in THX Surround EX or DTS-ES or in the normal 5.1-channel mode without using the surround back speakers when the software
is not recorded in THX Surround EX or DTS-ES.
OFF................Set the “OFF” mode to perform 6.1-channel playback with conventional 5.1-channel sources or sources on which the
identification signal described below is not recorded.
Non-Flag Source SB ch Output setting
THX surround EX/DTS ES..........Playback is conducted using the surround back speaker.
Surround back channel is reproduced using digital matrix processing.
Non MTRX.....Playback is conducted using the surround back speaker. The same signals as those of the surround channels are output from
the surround back channel.
OFF................Playback is conducted without using the surround back speaker.
NOTES:
• The “SB CH Auto Flag Detect” setting screen is displayed when the surround back speaker is set to “Large” or “Small” at “Speaker
Configuration”.
• The surround back speakers can also be turned on and off using the “SB CH OUT” surround parameter. (See pages 55.)
Select the setting according to the program source to be played.
To Next Page
Loading...
Need help?
General
