Denon AVR-4802 User Manual

58
Preset memory
1
Use the “Auto tuning” or “Manual tuning” operation to tune
in the station to be preset in the memory.
2
Press the MEMORY button.
3
Main unit:
Press the MODE SELECT button until “TUNER PRESET”
appears on the set’s display.
Remote control unit:
Press the SHIFT button and select the desired memory block
(A to E).
TUNING
PRESET
(Main unit) (Remote control unit)
4
Main unit:
Select the desired preset channel (1 to 8).
Remote control unit:
Press the PRESET UP or DOWN button to select the desired
preset channel (1 to 8).
SELECT
(Main unit) (Remote control unit)
5
Press the MEMORY button again to store the station in the
preset memory.
To preset other channels, repeat steps 2 to 5.
A total of 40 broadcast stations can be preset — 8 stations
(channels 1 to 8) in each of blocks A to E.
4 3
3
2, 5
Checking the preset stations
The preset broadcast stations can be checked on the on screen display.
1
Press the ON SCREEN button repeatedly until the “Tuner Preset Stations” screen appears on the
on screen display.
1
(Remote control unit)
4
(Remote control unit)
(Remote control unit)

Denon AVR-4802 Specifications

General

Impedance	8 ohms
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
THD	0.05%
Signal-to-Noise Ratio	100 dB
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Component Video Inputs	3
Digital Inputs	5 (3 Optical, 2 Coaxial)
Type	AV Receiver
Channels	7.1
Input Impedance	47 kOhms
Input Sensitivity	200 mV
Inputs	5 Digital (3 Optical, 2 Coaxial)
Outputs	composite video, component video, optical digital
Audio D/A Converter	24-bit/192kHz