EasyManuals Logo

Denon AVR-4802 User Manual

Denon AVR-4802
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
55
Surround parameters r
EFFECT:
This parameter turns the effect signals with multi surround mode speaker effects on and off in the WIDE SCREEN mode. When this parameter
is turned off, the SBL and SBR channel signals are equivalent to the SL and SR channels, respectively.
LEVEL:
This parameter sets the strength of the effect signals in the WIDE SCREEN mode. It can be set in 15 steps, from 1 to 15. Set this to a
low level if the positioning or phase of the surround signals sounds unnatural.
SB CH OUT:
(1) Dolby Digital/DTS source
MTRX ON ........Playback is conducted using the surround back speaker.
Surround back chnnel is reproduced using digital matrix processing.
NON MTRX......Playback is conducted using the surround back speaker.
The same signals those of the surround channels are output from the surround back channels.
OFF ..................Playback is conducted without using the surround back speaker.
(2) Other source
ON ...................Playback is conducted using the surround back speaker.
OFF ..................Playback is conducted without using the surround back speaker.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: small, med.s (medium-small), medium, med.l (medium-large) and large. small recreates a small sound
field, large a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 300 ms.
TONE CONTROL:
This can be set individually for the separate surround modes other than Direct and Home THX Cinema.

Other manuals for Denon AVR-4802

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-4802 and is the answer not in the manual?

Denon AVR-4802 Specifications

General IconGeneral
Impedance8 ohms
Frequency Response10 Hz - 100 kHz (+1, -3 dB)
THD0.05%
Signal-to-Noise Ratio100 dB
Surround SoundDolby Digital, DTS, Dolby Pro Logic II
Component Video Inputs3
Digital Inputs5 (3 Optical, 2 Coaxial)
TypeAV Receiver
Channels7.1
Input Impedance47 kOhms
Input Sensitivity200 mV
Inputs5 Digital (3 Optical, 2 Coaxial)
Outputscomposite video, component video, optical digital
Audio D/A Converter24-bit/192kHz

Related product manuals