Denon AVR-4810 User Manual


Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsSettings
ENGLISH
Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup)
Exiting the GUI Menu
Press MENU while the GUI menu is displayed.
The GUI menu display disappears.
n
If there is a disparity between the results and the connection status,
or if an error message is displayed, check the error message against
the errors listed in the “Error Messages” section (vpage 36) and
perform Audyssey Auto Setup again.
If the result still differs from the actual connection status after
remeasurement or the error message still appears, it is possible
that the speakers are not connected properly. Turn the AVR-4810
off, check the speaker connections and repeat the measurement
process from the beginning. Turn the AVR-4810 off, check the
speaker connections and repeat the measurement process from the
beginning.
If you change a speaker position or orientation, perform Audyssey
Auto Setup again to obtain optimal equalizer correction.
•
•
•
NOTE
After performing Audyssey Auto Setup, do not change the
speaker connections or subwoofer volume. In event of a change,
perform Audyssey Auto Setup again.
Main remote control unit
operation buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
STEP6 Store
7
Select “Store” and
then press ENTER.
Save the measuring
results.
The save operation
takes about 30 seconds
to complete.
b
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
RETURN
STEP6 Store
Press “St ore ” t o s tor e c alc ula tio n r esults.
Apply and store measurement result
Enter Cancel
Store
NOTE
During saving of measuring results, be sure not to turn off the
power.
8
When the screen
shown on the right
appears, unplug the
setup microphone
from the AVR-4810
SETUP MIC jack.
AUDYSSEY AUTO SETUP
1 2 3 4 5 6
Finish
Storing c omp let e.
Auto Setu p i s n ow fin ish ed.
Please un plu g m icr oph one .
Terminate auto setup
Enter
Exit
9
Select “Exit” and then press ENTER.

Denon AVR-4810 Specifications

General

Impedance	8 Ω
Frequency range	10 - 100000 Hz
Audio output channels	7.1 channels
Total Harmonic Distortion (THD)	0.05 %
Equalizer	Yes
Product color	Black
S-Video inputs quantity	7
Component video (YPbPr/YCbCr) in	3
HDMI ports quantity	6
Connectivity technology	Wired & Wireless
Headphone connectivity	3.5 mm
Digital audio optical out	1

Weight and Dimensions

Weight	19100 g