Denon AVR-E400

83
Speaker connection
Connecting 6.1-channel speakers using one surround back
speaker
If using only one surround back speaker, connect to the “L” side of the SURROUND BACK terminal.
For speaker settings in this case, see “When 6.1-channel speakers are installed” (vpage78).
To perform 6.1-channel playback using the surround back speaker, set “Assign Mode” to “Surround Back”
in steps 3 to 5 for “Set up “Amp Assign”” (vpage86).
Also use the “Speaker Config.” setting (vpage116) to set “Surr. Back” to “1spkr”.
NOTE
•For speaker cable connections, see page79.
•For speaker impedance, see page79.
FL FR
C
SL
SR
SW
SB
Basic instructions
Advanced instructions
Information
Advanced instructions
DVD