EasyManuals Logo

Denon AVR-S900W Service Manual

Denon AVR-S900W
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
Check the connection environment
YES
YES
YES
YES
YES
Are the network settings of this unit correct?
Are peripheral devices such as the router and hub connected cor-
rectly?
Are the router settings correct?
Set the IP address, etc. correctly.
If the IP settings are xed, check that no
other devices have the same IP address and
that the subnet mask settings are correct.
Connect the peripheral devices correctly.
Check the instruction manual of the router
and congure the settings correctly.
Check that there are no connection restric-
tions by MAC addresses, etc.
NO
NO
NO
5. Network/Bluetooth/USB
5.1. Cannot connect to the network
Is the LAN cable correctly inserted?
Insert the LAN cable correctly and then turn
on the power again.
NO
Check the connection environment
Checking the unit
90

Table of Contents

Other manuals for Denon AVR-S900W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-S900W and is the answer not in the manual?

Denon AVR-S900W Specifications

General IconGeneral
Channels7.2
HDMI Inputs8
HDMI Outputs2
Wi-FiYes
BluetoothYes
4K Ultra HD Pass-throughYes
Dolby AtmosYes
DTS:XNo
HDMI Pass-ThroughYes
Input Impedance47 kOhm
Input Sensitivity200 mV
THD at rated output0.08%
Signal-To-Noise Ratio98 dB
DAC Resolution24-bit / 192kHz
HDMI SwitchingYes
AirPlayYes
DLNAYes
Dimensions17.1 x 6.6 x 13.3 inches
Power Output90 W
Response Bandwidth10Hz-100kHz
Output Impedance / Channel6 Ohm
InputsHDMI
OutputsHDMI
Supported Audio FormatsMP3, WMA, AAC, FLAC, WAV
Supported Video Formats4K
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals