2. PANEL / REMOTE LOCK Selection Mode
2.1. Actions
Switch the PANEL LOCK and REMOTE LOCK modes between on and off.
2.2. Starting up
While holding down buttons "
TUNER PRESET CH+
" and "ZONE2 SOURCE" simultaneously, press the 
power button to turn on the power.
Select the desired mode using the "
TUNER PRESET CH+/-
" button, then press the "
STATUS
" button to 
conrm.
2.3. Displaying and Selecting Each Mode
The information shown on the display switches each time the "
TUNER PRESET CH+
" button is 
pressed.
Press the "
STATUS
" button to set the currently displayed mode and restart the device.
The setting with "
*
" is selected for each mode.
q 
 
 FP/VOL LOCK*On 
         The buttons on the unit and the master volume knob does not function.
                   
w 
 
 FP LOCK     On 
        The buttons on the unit does not function.
                   
e 
 
 FP LOCK     Off
        The PANEL LOCK mode is turned off.
                   
r 
 
 RC LOCK     On 
        The device cannot be operated by the remote control.
                   
t 
 
 RC LOCK    *Off
        The REMOTE LOCK mode is turned off.
    
112
Caution in 
servicing
Electrical Mechanical Repair Information Updating