Denon AVR-X4100W

5.1ch + ZONE2
(Default):
0
Setting to assign the power amplifiers in this unit
for ZONE2 to 2-channels.
5.1ch +
ZONE3 :
0
Setting to assign the power amplifiers in this unit
for ZONE3 to 2-channels
5.1ch +
ZONE2/3-
MONO :
0
Setting to assign the power amplifiers in this unit
for ZONE2 and ZONE3 each to a different
channel.
5.1ch (Bi-
Amp) :
0
Setting to assign the power amplifiers in this unit
for front speaker bi-amp connection to 2-
channels.
7.1ch/2ch
Front :
0
Setting to assign the power amplifiers in this unit
for connecting 2-channel playback speakers to 2
channels.
0
You can switch the front speakers when using 2-
channel playback in direct mode or stereo mode,
or when using multi-channel surround playback.
When setting speakers for 2-channel playback, also
perform the “2ch Playback” setting.
(v
p. 235)
5.1ch +
Front B :
0
Setting to assign the power amplifiers within this unit
for connecting the second set of front speakers.
0
You can switch between the desired combination of
front speakers A and front speakers B.
Switch the front speaker using the “Front Speaker”
setting. (v p. 235)
Dolby
Atmos :
0
Setting to assign the power amplifiers within this unit
for the speaker layout suitable for Dolby Atmos
playback. (v p. 225)
Upgrade (Auro-3D)
Auro-3D:
0
Setting to assign the power amplifiers with this unit
for the speaker layout suitable for Auro-3D playback.
0
This is a layout that adds the front height and
surround height speakers to the basic 5.1 channel
layout. Connect the front height speakers to the
HEIGHT1 speaker terminals and the surround height
speakers to the HEIGHT2 pre-out terminals.
Contents Connections Playback Settings Tips Appendix
218
Front panel Display Rear panel Remote Index