n
Registering multiple players at the same time
1
Press and hold down QUICK SELECT 1 – 4 and OPTION
until the DEV, TV and AVR indicators on the remote are
flashing green, then release.
Devices to be registered at the
same time
Press and hold down
the buttons
Blu-ray Disc
player
DVD player CD player
P P
QUICK SELECT 1 and
OPTION
P P
QUICK SELECT 2 and
OPTION
P P
QUICK SELECT 3 and
OPTION
P P P
QUICK SELECT 4 and
OPTION
NOTE
Depending on the model and year of manufacture of your device, some buttons may
not operate. In this case, try “Registering by entering preset numbers” (v p. 257).
o
Registering by entering preset numbers
Before starting, confirm the preset number of the device that you want
to register and the buttons that can be registered in the “Preset Code
Table”
(v
p. 327) in the Appendix.
1
Press and hold down the input source button that you
want to register the preset code to and SETUP until the
DEV, TV and AVR indicators are flashing green.
2
Enter the preset number (5 digits) listed for the device
in the Preset Code Table using the number buttons (0 –
9) on the remote control.
Some manufacturers use more than one type of preset code. Preset codes to change
the number and verify correct operation.
NOTE
Depending on the model and year of manufacture of your device, some buttons may
not operate.
Contents Connections Playback Settings Tips Appendix
257
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
Weight and Dimensions
