3.7. TUNER STEP mode (E2/E3 only)
3.9.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3.9.2. Starting up
Hold down buttons "
STATUS
" and "
ZONE3 SOURCE
" at the same time and press the power button to turn on the pow-
er.
Select the "5. TUNER FRQ SET" using the button "
CURSOR
f
/
d
", and press the button "
ENTER
" to commit the selection.
3.9.3. Displays
Start this unit in TUNER STEP mode, select using button "
CURSOR
0
/
1
" and enter using button "
ENTER
".
The following information is displayed in the following order.
(1) AM9kHz/FM50kHz selected
FLD
L1
* T U N E R F R Q S e t
L2
< A M 9 / F M 5 0 >
"
CURSOR
0
" "
CURSOR
1
"
(2) AM10kHz/FM200kHz selected
FLD L2
< A M 1 0 / F M 2 0 0 >
"
ENTER
"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
74
To Next Page
Loading...
