Denon AVR-X4100W

Sound modes and surround parameters
Sound mode
Surround Parameter
Dialog Level
Adjust
Subwoofer
Level
Adjust
Cinema EQ Loudness
Management
z
1
Dynamic
Compression
z
2
Low
Frequency
Effects
z
3
Delay Time Effect Level Room Size Speaker
Select
Direct/Pure Direct (2-channel)
z
4 S
z
5
SS
Direct/Pure Direct (Multi-channel)
z
4
SS SSS
DSD Direct (2-channel)
S
z
5
DSD Direct (Multi-channel)
z
4
SS S
Stereo
S SS
Multi Ch In
SSS S
Dolby Surround
SSSSS
DTS Neo:X
SSSSS S
Audyssey DSX
®
SSSSSS
Dolby Digital
SSSSSS
Dolby Digital Plus
SSSSSS
Dolby TrueHD
SSSSSS
Dolby Atmos
SSSSSS
DTS Surround
SSS SS
DTS 96/24
SSS S
DTS-HD
SSS S
DTS Express
SSS S
Multi Ch Stereo
SS SSS S
Rock Arena
SS SSS S S
Jazz Club
SS SSS S S
Mono Movie
SS SSS S S
Video Game
SS SSS S S
Matrix
SS SSSS S
Virtual
SS SSS
z
1 -
z
5 : “Sound modes and surround parameters” (v p. 287)
Contents Connections Playback Settings Tips Appendix
285
Front panel Display Rear panel Remote Index
Sound mode
Surround Parameter
Tone
z
6
Audyssey
Restorer
z
9
Center Spread Center Gain
MultEQ
®
XT 32
z
7
Dunamic EQ
z
8
Dunamic
Volume
z
8
Audyssey
LFC
TMz
8
Audyssey
DSX
®
Direct/Pure Direct (2-channel)
z
4
Direct/Pure Direct (Multi-channel)
z
4
DSD Direct (2-channel)
DSD Direct (Multi-channel)
z
4
Stereo
SSSSS S
Multi Ch In
SSSSSS
Dolby Surround
S SSSSS S
DTS Neo:X
SSSSSS S
Audyssey DSX
®
SSSSSS
Dolby Digital
SSSSSS
Dolby Digital Plus
SSSSSS
Dolby TrueHD
SSSSSS
Dolby Atmos
SSSSS
DTS Surround
SSSSSS
DTS 96/24
SSSSSS
DTS-HD
SSSSSS
DTS Express
SSSSSS
Multi Ch Stereo
SSSSS S
Rock Arena
SSSSS S
Jazz Club
SSSSS S
Mono Movie
SSSSS S
Video Game
SSSSS S
Matrix
SSSSS S
Virtual
SSSSS S
z
4,
z
6 -
z
9 : “Sound modes and surround parameters” (v p. 287)
Contents Connections Playback Settings Tips Appendix
286
Front panel Display Rear panel Remote Index
z1
This item can be selected when the Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played back.
z2
This item can be selected when the Dolby Digital, Dolby Digital Plus, Dolby TrueHD, Dolby Atmos or DTS is played back.
z3
This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z4
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z5 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 224)
z6 This item cannot be set when “Dynamic EQ” is set to “On”. (v
p. 175)
z7
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z8
This item cannot be set when “MultEQ
®
XT32” in the menu is set to “Off”. (v p. 174)
z9
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Contents Connections Playback Settings Tips Appendix
287
Front panel Display Rear panel Remote Index
99